5-101.bk Page 58 Friday, March 17, 2006 11:05 AM All E7 production engines starting with serial No. 2X0000 and above, feature valve lifters with no hole as well as inlet and nonbrake push rods with 0.060 inch (1.524 mm) maximum flat or dimple on the push rod ball end. Refer to Figure 6-68. 1. Lubricate the yoke guide pins (5) with clean engine oil. Installation If the engine is equipped with a Jake Brake, the exhaust valve yokes will have a larger rocker arm contact surface. The yokes with the larger surface must be installed on pins corresponding with the Jake Brake actuators. Used push rods have established wear patterns.
Push rods being returned to service should be installed in the same position from which they were removed. 2. Place the valve yokes (2) on the yoke guide pins from which they were removed. Slightly rock the yokes from side to side to be sure they are seated on the valve stems (4). 1. Apply lubricating oil to spherical end of the push rod and insert it into the lifter opening. Ensure that it has engaged the lifter by lifting it slightly. If the lifter has been properly contacted, some resistance will be felt in the rod as the lifter is raised. Engines equipped with Jake Brake: Effective January 1994 (engine serial No.
401269), the E7 Jake Brake yoke was manufactured with metric threads utilizing the Spiralock™ thread form. Refer to Section 7, SETUP AND ADJUSTMENTS, under Valve Yoke, Valve Lash and Slave Piston Adjustments (with Jake Brake) for details regarding correct method to loosen the yoke adjusting screw. 2. Repeat step 1 until all 12 push rods are in position. [213 NV] VALVE YOKES Description There are two exhaust valves and two inlet valves for each cylinder. Each rocker arm, in conjunction with the valve yoke, operates both valves together, in a set (exhaust or inlet), per cylinder. Installation Used yokes have established wear patterns.
Yokes being returned to service should be installed in the same position from which they were removed. Figure 6-68 — Valve Yoke Page 6-58 200 ENGINE ASSEMBLY 1. Rocker arm 2. Valve yoke 3. Yoke adjusting screw 4. Jam nut 5. Valve stem 6. Yoke guide pin