Mack Trucks — 5-101.bk

5-101.bk Page 59 Friday, March 17, 2006 11:05 AM [213 LP] ROCKER ARMS Description The valve rockers pivot on a shaft supported by three brackets per cylinder head. Two capscrews secure each bracket to the cylinder head. The rocker arms are operated by a camshaft through valve lifters and push rods extending through the cylinder heads. A coil spring returns each valve to the closed position, holding the rocker arm in contact with the push rod. Installation (Non-Brake and Dynatard Equipped Engines) Refer to Figure 6-69. 1. Position the rocker arm assemblies on the cylinder heads. Figure 6-69 — Valve Rocker Arm Installation Installation (Jake Brake-Equipped Engines) 2.

Ensure that the ball end of the rocker arm adjusters are in position in the push rod cups. Make sure that adjusting screws are retracted upward in the rocker arms. If extended far below rocker arm, the push rods can be bent when tightening the rocker arm assembly brackets. Use only Jacobs exhaust rocker arm adjusting screws for Jacobs engine brake installation. Using a MACK or any other type of screw will result in severe screw wear and engine damage. Jacobs exhaust rocker screws have hex heads. MACK screws have a screwdriver slot. 3. Lubricate the threads of the rocker arm mounting capscrews with clean engine oil.

Install the capscrews and torque to 40 lb-ft (54 N m) using torque wrench J 24407 or equivalent. Refer to Figure 6-70. Verify that Jacobs exhaust rocker arm adjusting screws are installed in the exhaust rocker arms. 4. Adjust valve and engine brake slave piston lash settings as applicable. Refer to the SETUP AND ADJUSTMENTS section in this manual for correct specification. Turn the screws all the way into the rocker arms from the underside. Install the MACK locknuts. 1. Install the rocker arm assemblies. Apply clean engine oil to the MACK hold-down capscrews. Install one capscrew with a washer in each bracket next to the push rods. Each rocker assembly has three brackets.

Page 6-59 200 ENGINE ASSEMBLY