5-101.bk Page 60 Friday, March 17, 2006 11:05 AM 2. Check that all push rods are in their sockets and rocker adjusting screws are backed out to prevent piston damage or bent rods. Brake Housing Installation Refer back to Figure 6-70. 3. Start at the center and tighten each bracket hold-down screw in two steps: 1. Lubricate the oil supply screw O-rings with clean engine oil. Torque to 20 lb-ft (27 N•m). 2. Place the engine brake housing in position on the rocker arm shaft brackets. Be sure the housing marked FRONT is over cylinders 1, 2 and 3, and the housing marked REAR is over cylinders 4, 5 and 6. Position the housings so that the oil supply bores are located over the oil supply screws.
Carefully push the housings down until the O-rings enter the bores and the housings rest flat against the rocker-arm shaft brackets. Retorque to 40 lb-ft (54 N•m). 4. Lubricate and install O-rings in the groove in the Jacobs oil supply screws. Install the screws into the rocker brackets and tighten to 5 lb-ft (7 N•m). 3 5 4 3. Lubricate all six Jacobs hold-down capscrews with clean engine oil and install them through the housings and into the rocker shaft brackets. 2 6 4. Start with the center capscrew on each housing and tighten them to 20 lb-ft (27 N•m). Retorque each, starting with the center capscrew, to 45 lb-ft (61 N•m) using torque wrench J 24407 or equivalent. 1 15 16 5.
Check for interference between rocker arm and slave piston by manually moving each rocker arm with the valves closed. Be sure to check all cylinders. If binding occurs, loosen the capscrews and reposition the housing. 14 13 7 7 7 8 12 11 6. Connect wiring to Jake actuator solenoid. 10 7. Adjust yoke, valve and Jake brake slave piston lash as needed. Refer to the SETUP AND ADJUSTMENTS section in this manual for correct specifications and procedures. 9 9 Figure 6-70 — Valve Rocker Arm Installation (with Jake Brake) 200263a Page 6-60 200 ENGINE ASSEMBLY 1. Wire connector 2. Riser 3. Valve cover 4. Short capscrew 5. Long capscrew 6. Actuator capscrew 7. Rocker arm shaft bracket 8. Valve yoke 9.
Head bolt with threaded hole 10. Push rod 11. Rocker arm assembly 12. Washer 13. Capscrew 14. Connector 15. Actuator assembly 16. Actuator solenoid