5-101.bk Page 61 Friday, March 17, 2006 11:05 AM [213 JB] VALVE COVER Description Valve cover mounting capscrews have undergone a manufacturing change. The existing mounting capscrews require two different sockets for cover installation. The new capscrews require only one socket. Note the capscrews used on your engine and replace with the same capscrews, if required. 3 Cylinder head cover (No. 337GB494M2) used on E7, CH 4 x 2 models with Jake Brake and air conditioning, contacts the air-conditioning expansion valve (mounted on the cab fire wall) during articulation. To eliminate this engine/cab interference condition, a new rear cylinder head cover (No. 337GB4108M) is available.
2 2 3 1 200581a The valve cover (and riser, if equipped with Jake Brake, Figure 6-73) requires a strip-type seal valve cover gasket, 51 inches (130 cm) in length. Figure 6-71 — Gasket Installation Sealing compounds are not necessary. Installation Refer to Figure 6-72. 2. Position the riser (4) on the cylinder heads. 3. Connect the actuator wire to the actuator (3). Refer to Figure 6-71. 4. Install a seal strip in the valve cover seal groove of the valve covers. Installation procedures for riser and valve cover seal are identical. a. Thoroughly clean the gasket contact surface. b.
Install one end of valve cover gasket into seal groove (inboard side) approximately 1/4 inch (6.4 mm) from the end of the groove. 1. Install a seal strip (2) in the seal grooves (3) of the risers. a. Thoroughly clean the gasket contact surface. c. Guide the seal strip into the groove around the circumference of the valve cover. Complete installation and overlap at the starting point approximately 1/4 inch (6.4 mm) from the end of the groove. b. Install one end of riser gasket into seal groove (inboard side) approximately 1/4 inch (6.4 mm) from the end of the groove. c. Guide the seal strip into the groove around the circumference of the riser.
Complete installation and overlap at the starting point approximately 1/4 inch (6.4 mm) from the end of the groove. 5. Position valve covers (1) on the cylinder heads or on the risers (4), if equipped. Page 6-61 200 ENGINE ASSEMBLY 1. Valve cover 2. Seal strip 3. Seal groove