Mack Trucks — 5-101.bk

5-101.bk Page 62 Friday, March 17, 2006 11:05 AM 6. Lubricate threads of the capscrews (2) and secure the valve covers with the lubricated capscrews. Torque capscrews to 16 lb-ft (22 N m). If replacing an existing manifold (on engines manufactured before March 1995) with a low- boss exhaust manifold and reusing the long studs (103 mm long), each stud requires a spacer. 1 2 When installing a low-boss exhaust manifold on a pre-1992-1/2 E7 V-MAC engine with injection line brackets fastened to the exhaust manifold, spacer and 113 mm studs are required. The new manifold fastener arrangements do not require washers or lockplates.

When installing new fasteners on an engine that uses washers and lockplates, discard those parts and replace both with the new fasteners. 3 4 200355a Figure 6-72 — Valve Cover Installation Installation Refer to Figure 6-73. 1. Install the 12 studs in position on the cylinder head. [214 EG] EXHAUST MANIFOLD 2. Position six manifold gaskets on the studs. Description In March 1995, a new exhaust manifold with a thicker mounting flange was introduced into production on all E7 engines. The mounting flange on this new “low-boss” exhaust is 3/4 inch (19.1 mm) thick, compared to the 1/2-inch (12.7 mm) thick mounting flange on the previous exhaust manifolds.

The new manifolds use mounting studs which are 60 mm (approximately 2-3/8 inches) long, and copper-plated flanged nuts without a locking feature. Exhaust manifold nuts must be installed dry (no lubrication). 3. Position the exhaust manifold on the mounting studs and secure with nuts. Torque the nuts to: 55 lb-ft (75 N m) for 10 mm nuts 65 lb-ft (88 N m) for 12 mm nuts E7 engines use a new-style exhaust manifold gasket without the stainless steel insert around the exhaust port opening as on previous gaskets. Engines with the older style exhaust manifolds must continue using the previously used “armored” exhaust manifold gasket. Page 6-62 200 ENGINE ASSEMBLY 1. Valve cover 2. Capscrew 3.

Actuator 4. Riser