. MAINTENANCE SERVICE PROCEDURE EVERY 250 HOURS SERVICE Maintenance for every 50 and 100 hours service should be carried out at the same time. CHECK BATTERY ELECTROLYTE LEVEL Carry out this procedure before operating the machine. WARNING the 3. If the electrolyte level is below the midway point between the U.L and L.L lines, remove cap (1) and add distilled water to the U.L line. 4. If distilled water has been added to any cell of cap (1), add distilled water also to the other cells. 5. Clean the vents of the battery caps, then close the caps securely. Keep the top of the battery clean and wipe it with a wet cloth.
the 4 - 44 Do not use the battery if the battery electrolyte level is bel ow the LOWER LEVEL line. This will accelerate deterioration inside of the battery and reduce the service life of the batt ery. In addition, it may cause an explosion. of explosion, do not bring fire or sparks near the battery. The battery generates flammable gas and there is danger Battery electrolyte is dangerous. If it gets in your eyes or o n your skin, wash it off with a large amount of water and con doctor. When adding distilled water to the battery, do not allow the battery electrolyte to go above the UPPER LEVEL line. to the paint surface or corrode other parts.
electrolyte level is too high, it may leak and cause damage NOTICE If there is a fear that the battery water may freeze after refilling with purified water (e.g. commercially available replenishment for a battery), do the replenishment before the day's work on the next day. Inspect the battery electrolyte level at least once a mo nth and follow the basic safety procedures given below WHEN CHECKING ELECTROLYTE LEVEL FROM SIDE O F BATTERY de of the battery, check as follows. the rear of the machine. rolyte level tween the nes. tricity may If it is possible to check the electrolyte level from the si 1. Open the cover of the battery box. There are two battery boxes: One on each side at 2.
Use a wet cloth to clean the area around the elect lines and check that the electrolyte level is be UPPER LEVEL (U.L.) and LOWER LEVEL (L.L.) li If the battery is wiped with a dry cloth, static elec cause a fire or explosion. REMARK If distilled water is added to above the U.L. line, use a syringe to lower the level to the U.L. line. Neutraliz removed fluid with baking soda (sodium bicarbonate), th en flush it away with a large amount of water or consult Komatsu distributor or battery maker.