Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST CHECKING NOTICE Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt is not touching the 4 - 48 (Machine eq uipped with cab) (If eq The standard pulley and cr ank pulley when pres sed with a thumb (approx. 98 (10 kg)) shou ld be approx. 16 to 2 0 mm (0.6 to 0.8 When a belt tension gauge is used , the standard te nsion is wit a range of 35 3 to 530 N (36 to 54 CHECK WHEN CHANGING THE V-BEL T The standard deflection between t he air conditione r compress or pulley and fan pulley when pressed with a thumb (approx.

98 N (10 kg)) should be a pprox. 12 to 17 mm (0.5 to 0 .7 in). 54 to 76 kg). When a belt tension gauge is used , the standard te nsion is wit hin a range of 530 to 745 N ( REMARK When the be lt has been replaced with a new part, a high tensio n is necessary, so the initial tension is in the value given above. ADJUSTING 1. Loosen n 2. Tighten n uts (1) and (2), and m ove compressor (3) to adju uts (1) and (2) to hol d compressor (3) in position. In case any territory to r • The fan b • A cut or c • Slipping of the following occurs, ask the Komatsu distributor in y eplace the belts with new ones. elt has elongated, leaving little allowance for adjustmen rack is found on the bel t.

rd coming from the belt. t it after one hour of operation. or creaking sound is hea rd coming from th When the n ew V-belt is set, readjus t it after one hour o