Komatsu — METHOD OF OPERATING AUTO-GREASING SYSTEM

. ATTACHMENTS, OPTIONS HANDLING AUTO-GREASING SYSTEM ATTACHMENTS, OPTIONS HANDLING AUTO-GREASING SYSTEM mode. REPLACEMENT OF GREASE CARTRIDGE WARNING 6 - 35 9. ompleting the setting, press the ESC key to leave t he setting REMARK Even if i t is desired to chan ge only one item, a lways car ry out the setting according to Steps 4 to 8. After completing th to leave the setting mode. e setting, always press the ESC key to leave the setting If the power is then turned ON, the count for th e greasin g interval wi ll s tar t immediately after the ESC key is pr essed. P art of the display segment flashes to indicate that the s ystem is counting.

After setting, the set value i s retained in memor y even if t he power is turned OFF. CHECK AMOUNT OF G 1. T urn the starting switch 2. Check the display of th e pilot lamp on the machine monitor. f th e pilot lamp is flash ing at 1-second intervals, it m eans that he grease cartridge is Replace the grease ca rtridge with a new c Ai r bleeding of pump involv es danger because of high press ure. Ask your Komatsu distributo r for air bl Be careful of the force appl ied by spring (2) instal led inside the cover. NOTICE After replacing cartridge,make sure to reset number counter on controller. (Refer to "TROUBLESHOOTING (PAGE 6-37)"