Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 9.2 REMOVAL OF THE DD13 TURBOCHARGER Cleaning the turbocharger is necessary before removal. PERSONAL INJURY To avoid injury from hot surfaces, wear protective gloves, or allow engine to cool before removing any component. PERSONAL INJURY To avoid injury from contact with rotating parts when an engine is operating with the air inlet piping removed, install an air inlet screen shield over the turbocharger air inlet. The shield prevents contact with rotating parts. Prior to removal, visually check for:

Missing or loose nuts and bolts Loose or damaged intake and exhaust ducting Damaged oil drain lines Cracked or deteriorating turbocharger housing External oil leakage or exhaust leaks Replace damaged parts with new parts. To remove the turbocharger, perform the following: NOTICE: Do not attempt to remove carbon or dirt buildup on the compressor or turbine wheels without removing the turbocharger from the engine. If chunks of carbon are left on the blades, an unbalanced condition will exist and subsequent failure of the bearings will result if the turbocharger is operated. However, it is not necessary to disassemble the turbocharger to remove dirt or dust buildup. 1.

Remove the turbocharger heat shields. 2. Disconnect the turbocharger ducting. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 9-5