9.2 REMOVAL OF THE DD13 TURBOCHARGER 3. Disconnect and remove the CAC ducting at the compressor housing. Remove the compressor outlet elbow and inlet elbow. 4. Remove the turbocharger oil supply and drain lines from the engine block and from the turbocharger. Remove the O-ring from the cylinder block. 5. Remove the fuel inlet line and coolant inlet and outlet lines from the doser injection valve. 6. To prevent coolant from spilling without draining the coolant system, cap the banjo bolt inlet and outlet coolant lines with a nut. 7. Disconnect the electrical wiring harness from the turbocharger speed sensor. All information subject to change without notice.
9-6 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION