EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 8. For EPA10 DD13 engines, remove the clamp (2) from the Electronic Proportioning Valve (EPV) air hose to the turbocharger and remove the hose (1) from the EPV. NOTE: Leave the air hose (1) connected to the turbocharger. 9. Remove the right side radiator support mount from the engine block. 10. Remove flange exhaust manifold from turbocharger housing. 11. Remove the four nuts from the studs attaching turbocharger to the exhaust manifold center section.
PERSONAL INJURY To avoid injury when removing or installing a heavy engine component, ensure the component is properly supported and securely attached to an adequate lifting device to prevent the component from falling. 12. Attach a chain hoist and a suitable lifting sling to the turbocharger assembly. 13. Remove the two bolts from the turbocharger support bracket to the cylinder block. 14. Lower the turbocharger assembly away from the exhaust manifold and place it on a bench. 15. Discard the turbocharger gasket. 16. Cover the end of the oil supply line, the oil drain line, the air inlet and the exhaust outlet openings on the engine and turbocharger to prevent entry of foreign material.
All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 9-7