Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

11.5 EGR COOLER CLEANING PROCEDURE TO REMOVE EXCESS OIL FROM EGR COOLER AFTER DD15 TURBOCHARGER FAILURE Check as follows: NOTICE: This cleaning procedure must be followed after replacing a DD15 turbocharger so that any failure will not cause excessive fuel, oil, or coolant to enter the exhaust system. Failure to perform this procedure could cause severe engine damage. 1. Shut off the engine, apply the parking brake, chock the wheels, and perform any other applicable safety steps. 2. Remove the EGR hot pipe (4) and gaskets (3) and inspect for any signs of liquid or moisture. The hot pipe and EGR cooler inlet should have a black dry soot residue inside.

[a] If liquid or moisture is present in the pipe, go to the next step. [b] If there is no sign of liquid or moisture in the pipe or EGR cooler, install the hot pipe. No further action is required. 3. Remove the mixer pipe (4) from the cold boost pipe (1). Refer to section . All information subject to change without notice. 11-12 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION