Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 4. Remove the exhaust gas crossover tube/lifting eye (2) Refer to section and venturi (3). Refer to section . 5. Place a towel over the outlet of the EGR cooler and retain it with a zip tie. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 6. Using a rubber tipped blow gun, blow compressed shop air into the individual tubes in the EGR cooler to clear any excess fuel, soot, and carbon. 7. After performing the cleaning procedure, refer to section to install the: [a] mixer pipe.

[b] exhaust gas crossover tube/lifting eye (EPA07 engines) and exhaust gas crossover tube (EPA10 engines). [c] venturi. 8. If the cooler has an excessive amount of buildup that cannot be removed, replace the EGR cooler. Refer to section . All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 11-13