EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 18. Remove the EGR crossover tube. Refer to section . 19. Remove the two bolts attaching the cold boost pipe to the support bracket. 20. Using Flywheel and Main Pulley Socket tool (J-45390), remove the 40 bolts securing the cylinder head to the cylinder block. 21. If the dipstick hose is attached to the intake throttle valve bracket, remove the clip attaching it. PERSONAL INJURY To avoid injury when removing or installing a heavy engine component, ensure the component is properly supported and securely attached to an adequate lifting device to prevent the component from falling. 22.
Using Cylinder Head/Engine Lifting Bar tool (W470589006200), remove the cylinder head from the cylinder block. 23. Remove and discard the metallic gasket from the cylinder block. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 14-11