Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

14.3 INSTALLATION OF THE DD13 CYLINDER HEAD 14.3 INSTALLATION OF THE DD13 CYLINDER HEAD Install the cylinder head as follows: 1. Inspect the head bolt holes in both block and head for the presence of oil, water, dirt, or damaged threads; clean or re-tap as necessary. Ensure piston domes, cylinder head, and cylinder block fire deck surfaces are clean and free of foreign matter. 2. Verify that the cylinder liner protrusion heights are within specification prior to installing the cylinder head. Refer to section 16.5for cylinder liner protrusion specifications. 3. Install cylinder head guide studs (W471589016100). 4. Position a new cylinder head gasket onto the cylinder block. 2.

Engine Oil Return Opening 5. Opening for Blow-by Duct to Crankcase Vent 1. Engine Oil Feed Hole 4. Coolant Return Opening 3. Coolant Feed Hole PERSONAL INJURY To avoid injury when removing or installing a heavy engine component, ensure the component is properly supported and securely attached to an adequate lifting device to prevent the component from falling. 5. Install four lift hooks onto the cylinder head. All information subject to change without notice. 14-12 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION