EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 14.5 CLEANING OF THE CYLINDER HEAD Clean the cylinder head as follows: 1. Keep parts segregated according to original position to assure proper reassembly, if parts are to be reused. 2. Remove all plugs. 3. Steam clean the cylinder head once it has been stripped. 4. Clean the head in a de-scaling bath. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 5. Clean the valves, springs, and rocker shafts in fuel oil and blow dry with compressed air. 6. Clean the rocker arm assemblies.
All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 14-17