Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 14.7 INSTALLATION OF THE DD15 CYLINDER HEAD Install the cylinder head as follows: 1. Inspect the head bolt holes in both block and head for the presence of oil, water, dirt, or damaged threads, clean or re-tap as necessary. Ensure piston domes and the cylinder head and cylinder block deck surfaces are clean and free of foreign matter. 2. Verify that the cylinder liner protrusion heights are all the same prior to installing the cylinder head. 3. Install Cylinder Head Guide Studs tool (J-35784). 4. Position a new cylinder head gasket onto engine block. 1. Engine Oil Feed Hole 4. Coolant Return Opening 2. Engine Oil Return Opening 5.

Opening for Blow-by Duct to Crankcase Vent 3. Coolant Feed Hole PERSONAL INJURY To avoid injury when removing or installing a heavy engine component, ensure the component is properly supported and securely attached to an adequate lifting device to prevent the component from falling. 5. Install four lift hooks onto cylinder head. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 14-19