15.2 REMOVAL OF PISTON AND CONNECTING ROD ASSEMBLY 7. Remove the piston cooling nozzles (1) from the base of the cylinder bores and discard the nozzles. 8. Position the crankshaft for each piston and connecting rod assembly to be removed at bottom dead center. 9. Remove the connecting rod bearing cap with lower bearing shell from the connecting rod. NOTICE The connecting rod assembly is a cracked rod design. Ensure when the bearing cap is removed that it is placed on its side. Damage to the bearing cap will occur if it is placed on end; the connecting rod assembly will need to be replaced if the cap is damaged. 10.
Remove the piston and connecting rod assembly through the top of the cylinder liner. 11. Assemble the connecting rod bearing cap and lower bearing shell to the connecting rod after removal. If not already marked, match-mark the rod and cap (on the tang side) with the cylinder number from where they were removed. NOTE: When removed, the bearing cap and the bearing shell must be assembled to its original connecting rod before another connecting rod bearing cap is removed. All information subject to change without notice. 15-6 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION