EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 15.3 DISASSEMBLY OF PISTON AND CONNECTING ROD ASSEMBLY Piston assembly components should be segregated by cylinder and match-marked during disassembly to ensure they are assembled in the same position and orientation. NOTICE: Stamping cylinder numbers on the piston assembly will damage the components. Disassemble piston and connecting rod assembly as follows: 1. Place the piston, dome down, on the table. 2. Using appropriate flat-nosed pliers, remove the retaining rings from the piston boss. 3. Slide out the piston wrist pin and remove the connecting rod from piston. All information subject to change without notice.
DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 15-7