EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 15.6 INSTALLATION OF PISTON AND CONNECTING ROD ASSEMBLY Install as follows: 1. If the rings have been removed, install them into the grooves of the piston and rotate 120° apart as follows: [a] Install the oil ring expander in the lowest groove in the piston. [b] Install the oil ring (top label up) in the lowest groove around the oil expander ring. [c] Install the compression ring (top label up) in the middle groove. [d] Install the fire ring (top label up) in the top groove. 2. Allowable new ring end gaps for (A), (B), and (C) are shown below. Table 15-1 Allowable Ring End Gaps 3.
Add clean engine oil to a clean pan at least 305 mm (12 in) in diameter, until the level reaches approximately 76 mm (3 in). 4. Place the piston and connecting rod assembly into the pan, with the combustion dome of the piston on the bottom of the pan. 5. Coat the upper connecting rod bearing shell with clean engine oil. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 15-11 Ring Ring End Gap Fire Ring (A) 0.35 - 0.75 mm (0.024 - 0.030 in.) Compression Ring (B) 0.7 - 0.9 mm (0.027 - 0.035 in.) Oil Control Ring (C) 0.4 - 0.6 mm (0.016 - 0.024 in.)