Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE [c] For the DD15, Piston Ring Compressor tool (W470589015900) may also be used. 8. Place piston on a bench with dome side down, install piston ring compressor tool. 9. Once the ring compressor is clamped, ensure the piston can rotate freely. If rotation is hindered, remove the compressor and reposition the dome and rings, or inspect for ring damage. 10. Lubricate the inside of the cylinder liner with clean engine oil. 11. Position the throw of the crankshaft to bottom dead center for the cylinder being installed with the piston and connecting rod assembly. NOTICE:

Failure to orient the piston and connecting rod assembly properly during piston installation may result in the bearing end of the rod striking the nozzle, causing damage to the nozzle or loosening it from the block. A damaged, bent, or loosened nozzle may cause a loss of main gallery pressure. In these cases piston overheating or lack of adequate lubrication may result in severe engine damage. 12. Ensure the valve relief located on the top of the piston is orientated towards the exhaust side of the engine during installation. The piston also has an arrow that should face the All information subject to change without notice.

DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 15-13