Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

15.6 INSTALLATION OF PISTON AND CONNECTING ROD ASSEMBLY front of the engine. The connecting rod has a serial number printing that must also face towards the exhaust side of the engine. 13. Align the ring compressor guide pins (if equipped) over the two bolt holes on the top of the cylinder block. NOTICE: DO NOT force the piston into the liner. Considerable force on the piston could scratch or otherwise damage the inside of the cylinder liner. Therefore, care must be taken during the installation of the piston to prevent damage. 14. With care and moderate pressure, press the piston into the liner. 15. Remove the ring compressor. 16.

Push or tap the piston and connecting rod within the liner until the upper rod bearing is firmly seated on the appropriate crankshaft journal. 17. Lubricate the lower bearing shell with clean engine oil. 18. With the number on the cap and rod on the same side and the arrow facing forward, install the bearing cap. All information subject to change without notice. 15-14 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION