15.6 INSTALLATION OF PISTON AND CONNECTING ROD ASSEMBLY 20. Check connecting rod axial clearance by moving the rod from side to side on the crank journal. If there is no clearance, check for proper bearing cap installation. Table 15-2 21. Install the remaining piston and rod assemblies in the same manner. NOTICE: Ensure when installing the piston spray nozzles that damage to the nozzle does not occur. Damaged oil spray nozzles could result in a loss of oil pressure to cool the pistons, which may cause engine damage. 22. Install new piston spray nozzles (1) at the base of the cylinder bores. Torque each piston spray nozzle bolt to 30 N·m (22 lb·ft). 23.
Using a dial gauge and holder, measure the piston protrusion relative to cylinder block top dead center at all the pistons. All information subject to change without notice. 15-16 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION Connecting Rod Axial Clearance DD13 0.12 mm (0.0047 in.) 0.29 mm (0.0114 in.) DD15 0.12 mm (0.0047 in.) 0.29 mm (0.0114 in.) DD16 0.12 mm (0.0047 in.) 0.29 mm (0.0114 in.)