EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 24. Allowable piston protrusion (A) is in the table below: 1. Piston 2. Cylinder Liner A. Allowable Piston Protrusion Table 15-3 Allowable Piston Protrusion 25. If piston protrusion is not between minimum and maximum specifications, check the following: [a] Inspect piston, piston pin boss, and piston pin for wear or damage. If damaged, repair as necessary. [b] Inspect connecting rod, checking for bent rod, piston pin bore wear or damage. If damaged, repair as necessary. [c] Inspect connecting rod bearings for wear or damage. If damage is found replace rod bearings. [d] Inspect crankshaft for damage to rod journal or evidence of spun bearing.
If damaged, repair as necessary. 26. Install a new cylinder head gasket. For DD13, refer to section 14.3. For DD15, refer to section 14.7. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 15-17 Engine Minimum Maximum DD13 -0.201 mm (-0.0079 in) 0.2215 mm (0.0087 in.) DD15 -0.213 mm (-0.0090 in.) 0.2075 mm (0.0081 in.) DD16 -0.213 mm (-0.0090 in.) 0.2075 mm (0.0081 in.)