Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

15.6 INSTALLATION OF PISTON AND CONNECTING ROD ASSEMBLY 27. Install the cylinder head. For DD13, refer to section 14.3. For DD15, refer to section 14.7. 28. Install the lubricating oil pump inlet pipe and screen assembly, and the lubricating oil pump. Refer to section 21.4. NOTE: Debris from a failed bearing can damage the internal components of the oil pump. If debris is found in the oil pan, replace the oil pump as necessary. 29. Install the oil pan. Refer to section 19.7. 30. Complete any other engine assembly as necessary. 31. After the engine has been completely assembled, refill the oil pan to the proper oil level on the dipstick. 32. Prime engine lubrication system.

Refer to section 27.1. 33. Close the drain cocks and fill the engine with the recommended coolant. NOTE: Coolant system maintenance is very important. Bleed off all the air from the system and top off. 34. Verify repairs made to the piston and connecting rod assembly. If new parts such as pistons, rings, cylinder liners or bearings were installed, operate the engine on the run-in schedule. All information subject to change without notice. 15-18 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION