16.2 REMOVAL OF CYLINDER LINER 16.2 REMOVAL OF CYLINDER LINER Remove as follows: NOTICE: The proper method must be followed when removing the cylinder liner. Damage to the liners and cylinder block may occur if the proper tools and procedures are not used. 1. Remove the piston and connecting rod. Refer to section 15.2. 2. Install cylinder liner removal tool (J-45876) into the cylinder liner. 3. Remove cylinder liner (2). NOTICE: After removing the liners from the engine and prior to installation, always store them in an upright position until ready for use.
Liners left on their side for any length of time can become egg-shaped and distorted, making installation in cylinder bores difficult or impossible. If the cylinder liners are to be reused, they should be marked for cylinder location and engine orientation, a paint mark can be used to indicate the front of the engine so they may be installed to the same cylinder from which they were removed. 4. Remove the two seal rings (1, 3) from the cylinder liner (2) and discard them. All information subject to change without notice. 16-4 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION