EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 16.3 INSPECTION OF CYLINDER LINER Inspect as follows: 1. Inspect the cylinder liner. [a] Check the cylinder liner for cracks or scoring. If cracks or scoring are present, replace the liner. NOTICE: Cavitation is due to poor cooling system maintenance. If uncorrected, it will eventually make holes through the liner. This can result in combustion gases blowing water out of the radiator, oil in the coolant, or when the engine is stopped will allow water to flow into the cylinder and result in major engine damage due to water in the oil or hydraulic lockup. [b] Check the cylinder liner for cavitation.
If indication of cavitation is present, replace the liner. [c] Check for bore polishing; if detected, replace the cylinder liner. 2. Inspect the outside diameter of the liner. [a] Check the liner for fretting. [b] If any fretting is found, remove it from the surface of the liner with a course, flat stone. 3. Inspect the liner flange in two steps: [a] Inspect the top surface of compression seal for cracks, smoothness and flatness. [b] Inspect the balcony (bottom stop). All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 16-5