Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

17.2 REMOVAL OF CRANKSHAFT 17.2 REMOVAL OF CRANKSHAFT When removal of the crankshaft becomes necessary, first remove the transmission, then proceed as follows: 1. Steam clean the engine. 2. Drain the cooling system. Refer to OEM procedures. 3. Drain the lubricating oil. Refer to OEM procedures. PERSONAL INJURY To avoid injury when removing or installing a heavy engine component, ensure the component is properly supported and securely attached to an adequate lifting device to prevent the component from falling. 4. Attach Cylinder Head/Engine Lifting Bar tool (W470589006200) with hooks to the three engine lifter brackets (one at the front and two at the rear).

Remove all engine-to-base attaching bolts and remove the engine from its chassis. FALLING ENGINE To avoid injury from a falling engine, ensure the engine is securely attached to the engine overhaul stand before releasing the lifting sling. All information subject to change without notice. 17-6 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION