Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 5. Remove and inspect all of the accessories and assemblies with their attaching parts, as necessary, to permit the engine block adaptor to be bolted to the intake (left) side of the cylinder block. Mount the engine to the overhaul stand (J–29109) with adaptor (J–35635–A). 6. Remove the oil pan. Refer to section 19.2. 7. Remove the oil pump. Refer to section 21.2. 8. Remove the flywheel. Refer to section 34.4. 9. Remove flywheel housing. Refer to section 34.2. NOTICE: Use care when removing the crankshaft pulley and vibration assembly. If the damper is allowed to fall, damage to the internal components of the damper may result. 10.

Loosen and remove two of the crankshaft pulley retaining bolts and hardened washers 180 degrees apart and install Flywheel Guide Studs tool (J–36235) in their place. Then loosen and remove the remaining six pulley retaining bolts and hardened washers. 11. Remove the vibration damper assembly. Refer to section 36.1. 12. Remove front cover. Refer to section 37.2. 13. Remove connecting rod caps, and/or piston assemblies (if necessary). Refer to section 15.2. 14. Rotate the engine so the crankshaft is facing up. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 17-7