Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

17.5 REMOVAL OF CRANKSHAFT REAR OIL SEAL 17.5 REMOVAL OF CRANKSHAFT REAR OIL SEAL Remove as follows: PERSONAL INJURY To avoid injury before starting and running the engine, ensure the vehicle is parked on a level surface, parking brake is set, and the wheels are blocked. 1. Remove the flywheel from the flywheel housing (1). NOTICE: When drilling pilot holes in the seal, ensure that the drill is straight and perpendicular to the seal. Failure to drill the holes straight could result in damage to the seal bore, resulting in replacement of the flywheel housing. NOTE: When drilling the holes for screws, make sure to coat the drill bit with grease to catch the shavings. 2.

Drill 3.174 mm (0.125 in) pilot holes in the seal (2); use the sheet metal screws and the Rear Crankshaft Seal Installer & Remover tool (W470589004300); remove the seal (2) and discard the seal. All information subject to change without notice. 17-14 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION