EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 17.6 INSTALLATION OF THE REAR OIL SEAL Install as follows: NOTE: The standard size rear oil seal has an inside diameter of 138 mm (5.433 in.). 1. Inspect the contact area of the flywheel for damage and wear. If it is scored or worn, replace it. 2. Install the new rear seal (2) onto the Rear Crankshaft Seal Installer & Remover tool (W470589004300). NOTE: For ease of installation into the flywheel housing, apply a light coating of a soapy water solution to the outer diameter (2) of the seal. 3. Position the seal into the flywheel housing (1). All information subject to change without notice.
DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 17-15