Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 19.7 INSTALLATION OF OIL PAN Install as follows: 1. When a plastic pan is used, insert the raised lip portion of the seal into the groove in the oil pan. Press down on the isolator seal and insert it completely around the oil pan. Be careful not to stretch or bunch the seal. For best results, install the seal at each corner, then at points half way between the corners. Continue in this manner, halving the distance and seating the seal. 2. For the aluminum pan, place the gasket on the top of the pan. 3. Reapply Loctite® 5970 or equivalent to the four corner squares in gasket. 4.

Install the eighteen oil pan bolts and sleeve assemblies through the pan rail into the holes in the gasket. 5. Ensure the joint surfaces of the gear case, the cylinder block, and front cover are cleaned and there is no damage that could prevent sealing. 6. Install the oil pan assembly in position on the cylinder block. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 19-9