Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

19.7 INSTALLATION OF OIL PAN 7. Ensure that the seal has not been disturbed. Torque the eighteen oil pan bolt assemblies to 20 N·m (15 lb·ft) using the proper sequence. 8. Install the oil pan drain plug and torque the plug to 45 N·m (33 lb·ft). 9. Install bolt at harness P-clamp on front center of oil pan. 10. Install dipstick tube fitting if removed from pan and torque to specification listed in Table 19-1. Table 19-1 Torque Specs for Pan Fittings 11. Install dipstick tube on fitting and tighten clamp. Refer to section 20.3. 12. Install dipstick. 13. Install oil filter and cap. Torque to 55 N·m (40 lb·ft). 14. If oil pump was removed, follow section 21.4. 15. Prime the lubrication system.

Refer to section 27.1. 16. Refill the oil pan with lubricating oil. (refer to specs for oil quantities). All information subject to change without notice. 19-10 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION Fitting Thread Size Torque Spec Fitting to pan M20x1.5 60 N·m (44 lb·ft) Fitting to pan M22x1.5 70 N·m (51 lb·ft) Fitting to pan M27x1.5 90 N·m (66 lb·ft) Fitting to pan M30x1.5 100 N·m (73 lb·ft)