EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 22.2 REMOVAL OF THE CRANKCASE BREATHER Remove as follows: 1. Disconnect speed sensor electrical harness connection, on EPA10 engines, from the crankcase breather and unclip the electrical harness from the crankcase breather assembly. NOTE: Note orientation of bracket located on top bolt. 2. On EPA07 engines, remove the two bolts and gasket from the breather pipe. Discard gasket. 3. On EPA10 engines, disconnect the quick-connect fitting at the cylinder block. 4. Remove the four bolts and gasket from the crankcase breather and remove crankcase breather from the cylinder block. Discard the gasket. All information subject to change without notice.
DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 22-5