Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 22.4 INSTALLATION OF THE CRANKCASE BREATHER Install as follows: 1. Install the crankcase breather to the engine block with a new gasket and four bolts. Torque the bolts to 60 N·m (44 lb·ft). NOTE: Bracket is installed on top bolt. 2. On EPA07 engines, install the breather pipe and new gasket to the engine block. Torque the two bolts to 30 N·m (22 lb·ft). 3. On EPA10 engines, snap the breather pipe to the fitting on the cylinder block. ENGINE EXHAUST To avoid injury from inhaling engine exhaust, always operate the engine in a well-ventilated area. Engine exhaust is toxic.

PERSONAL INJURY Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. Always start and operate an engine in a well ventilated area. If operating an engine in an enclosed area, vent the exhaust to the outside. Do not modify or tamper with the exhaust system or emission control system. 4. Connect electrical harness, if equipped. 5. Start the engine and check for leaks. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 22-7