EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 30.2 REMOVAL OF COOLANT THERMOSTAT AND SEAL Remove as follows: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 1. Drain the cooling system. 2. Remove the plug on the cylinder block below the oil coolant module to drain the remaining coolant. 3. Loosen hose clamp at the thermostat. 4. Remove the four thermostat housing-to-oil cooler module attaching bolts. 5.
Remove the thermostat housing assembly from the oil coolant module and hose. 6. Remove the thermostat housing seal. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 30-5