Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

34.1 DESCRIPTION AND OPERATION OF FLYWHEEL, FLYWHEEL HOUSING AND RELATED PARTS 34.1.3 Flywheel Housing The flywheel housing is a one-piece aluminum casting mounted against the rear of the engine. It provides a cover for the gear drive and houses the flywheel. The crankshaft rear oil seal, which is pressed into the housing, may be removed or installed without removing the housing. The power steering pump on some applications may be mounted on the flywheel housing. An engine barring or locking device can be attached at the opening on the bottom of the flywheel housing. This allows the engine to be barred or locked for maintenance or repair work. 1. Gasket 6. Nut 2. Seal 7. Flywheel Housing 3.

Stud 8. Cover 4. Stud 9. Bolt (2) 5. Access Hole Cover Figure 34-1 Rear of Flywheel Housing and Related Parts All information subject to change without notice. 34-4 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION