Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 34.3 INSTALLATION OF FLYWHEEL HOUSING Install as follows: 1. Thread two guide studs (J–43431) for 14 mm bolts, into the cylinder block to guide the housing in place. 2. Install a new gasket. BODILY INJURY To avoid injury from a falling component, ensure a proper lifting device is used. Never stand beneath a suspended load. 3. Using a lifting sling support the flywheel housing and position it onto the cylinder block. 4. Install all of the housing bolts in their proper location; finger-tighten them. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 34-7