34.3 INSTALLATION OF FLYWHEEL HOUSING 1. Bolt, M8 x 16 (2 qty.) 30 N·m (22 lb·ft) 6. Bolt, M8 x 45 (2 qty.) 30 N·m (22 lb·ft) 2. Bolt, M14 x 1.5 x 90 (6 qty.) 120 N·m (88 lb·ft) 7. Bolt, M8 x 30 (2 qty.) 30 N·m (22 lb·ft) 3. Bolt, M10 x 45 (6 qty.) 60 N·m (44 lb·ft) 8. Bolt, M14 x 1.5 x 70 (1 qty.) 120 N·m (88 lb·ft) 4. Bolt, M10 x 90 (3 qty.) 60 N·m (44 lb·ft) 9. Stud, (1 qty.) 5. Bolt, M14 x 1.5 x 180 (1 qty.) 120 N·m (88 lb·ft) 10. Nut, M12-10 (1 qty.) 100 N·m (74 lb·ft) 5. Remove the guide studs. 6. Torque the flywheel housing bolts using the sequence and torque shown. 8. Install the flywheel. Refer to section 34.6. 7. Inspect the crankshaft rear main oil seal.
If any damage is found, replace as necessary. 9. For the DD15; install the exhaust pipe and bracket to the flywheel housing and axial power turbine. Install two bolts into the bracket and flywheel housing. Install a clamp onto the exhaust pipe and axial power turbine. Refer to section 12.4. 10. Install the crankshaft position sensor. Refer to section . 11. Install the oil pan and fill the engine with new oil. 12. Prime the lubrication system. Refer to section 27.1 All information subject to change without notice. 34-8 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION