Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 34.4 REMOVAL OF THE FLYWHEEL Pre-cleaning is not necessary. Remove as follows: 1. Remove the crankshaft position sensor (CKP). Refer to section . 2. Remove eleven of the twelve flywheel attaching bolts, leaving one bolt at the 12 o'clock position. 3. Install two flywheel guide studs (J–41672) through the flywheel and into the crankshaft at the 3 and 9 o'clock positions. 4. Attach the flywheel lifting tool (J–25026) or some other suitable lifting device, to the flywheel. 5. Attach a chain hoist to the lifting tool. 6. Loosen, but do not remove the last flywheel attaching bolt.

FALLING FLYWHEEL To avoid injury from a falling flywheel when removing the last bolt, hold the flywheel against the crankshaft by hand to prevent it from slipping off the crankshaft. The flywheel is not doweled to the crankshaft. 7. Lift lightly on flywheel using lifting device and remove last bolt. BODILY INJURY To avoid injury from a falling component, ensure a proper lifting device is used. Never stand beneath a suspended load. 8. Remove flywheel. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 34-9