34.5 INSPECTION OF FLYWHEEL 34.5 INSPECTION OF FLYWHEEL Inspect as follows: 1. Inspect the clutch contact base of the flywheel. [a] Check clutch contact base for scoring, wear, or cracks. [b] The flywheel may be re-faced if the clutch contact face is scored or worn. [c] The flywheel must be replaced if the clutch contact face shows cracks. 2. Inspect the ring gear. [a] Check ring gear for excessively worn or damaged gear teeth. [b] If damaged gear teeth are detected, replace the ring gear. 3. Inspect crankshaft and flywheel contact surface. [a] Check the butt end of the crankshaft and flywheel contact surface for damage.
[b] Lightly stone the contact surface to remove any fretting, brinelling, or burrs. All information subject to change without notice. 34-10 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION