EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 34.6 INSTALLATION OF FLYWHEEL Install as follows: 1. Install two flywheel guide studs (J–36235) into two of the tapped holes in the crankshaft at the 3 and 9 o'clock position. NOTICE: Maximum flywheel bolt length for reuse is 88mm, if bolt length exceeds this, replace the used bolts with new bolts. 2. Properly attach the flywheel lifting tool to the flywheel and, using a chain hoist, position the flywheel in the flywheel housing. Align the flywheel bolt holes with the crankshaft bolt holes. Be sure to line up the locating pin hole with the pin on the crankshaft. 3. Remove the flywheel lifting tool and guide studs. 4.
Apply clean engine oil to the threads and to the bolt head contact area (underside) of the remaining bolts. Any excess must be wiped off. NOTE: Clean engine oil must never be used between two surfaces where maximum friction is desired, as between the crankshaft and the flywheel. 5. Install the flywheel lock J-46392 or W470589046300. 6. Install the bolts and torque them to 200-220 N·m (147-162 lb·ft) and then an additional 90° to 100° torque turn. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 34-11