Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

34.9 INSTALLATION OF RING GEAR 34.9 INSTALLATION OF RING GEAR Install the ring gear as follows: 1. Support the flywheel, ring gear side up, on a solid flat surface. BURNS To avoid injury from burning, use lifting tools and heat-resistant gloves when handling heated components. NOTICE: Do not, under any circumstances, heat the gear over 204°C (399°F). Excessive heat may destroy the original heat treatment. Heat treating “crayons” which are placed on the ring gear and melt at a predetermined temperature, may be obtained from most tool vendors. Use of these “crayons” will ensure against overheating the gear. 2. Rest the gear on a flat metal surface.

Heat the gear uniformly with an acetylene torch, keeping the torch moving around the gear to avoid hot spots. 3. Use a pair of tongs to place the gear on the flywheel with the chamfer, if any, facing the same direction as on the gear just removed. 4. Tap the gear in place against the shoulder of the flywheel. If the gear cannot be tapped into place readily so that it is seated all the way around, remove it, and apply additional heat. 5. Once the ring gear is installed, install the flywheel. 6. Install the transmission. All information subject to change without notice. 34-14 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION