EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 42.2 REMOVAL AND DISASSEMBLY OF ENGINE FROM THE VEHICLE Before mounting an engine on an overhaul stand, it must be disconnected from the transmission. Details for removing an engine will vary from one application to another. However, the following steps will be necessary, regardless of application: 1. Steam clean the engine. 2. Disconnect the battery cable(s) from the battery(s). 3. Drain the cooling system. Refer to OEM procedures. 4. Drain the lubricating oil. 5. Disconnect the lines on the fuel filter module from the fuel tank. 6. Remove the air cleaner ducting as necessary for engine removal. Refer to OEM guidelines. 7.
Remove the charge air cooler ducting from the turbocharger and intake manifold. 8. Disconnect the exhaust piping from the engine. 9. Remove the 21-pin connector from the MCM. 10. Disconnect wiring from the cranking motor and remove cranking motor. 11. Disconnect the alternator and other electrical equipment, as necessary. 12. Disconnect the air compressor air lines, as necessary. 13. Disconnect and remove the coolant hoses. 14. Remove the charge air cooler, radiator, fan guard and other cooling system related parts as necessary to remove the engine. 15.
Connect Cylinder Head/Engine Lifting Bar tool (W470589006200) to the engine using all three lifting brackets (two at the rear and one at the front). 16. Remove the engine mounting bolts. FALLING ENGINE To avoid injury from a falling engine, an adequate lifting device with a spreader bar and sling should be used to lift the engine. The sling and spreader bar should be adjusted so the lifting hooks are vertical to prevent bending the lifter brackets. To ensure proper weight distribution, all provided lifter brackets must be used. 17. Lift the engine from its mounts using W470589006200. All information subject to change without notice.
DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 42-9