42.2 REMOVAL AND DISASSEMBLY OF ENGINE FROM THE VEHICLE FALLING ENGINE To avoid injury from a falling engine, ensure the engine is securely attached to the engine overhaul stand before releasing the lifting sling. 18. Separate the engine from the transmission. 19. Remove the fuel filter module. Refer to section . 20. Remove high pressure pump. Refer to section . 21. Use engine overhaul stand (J–29109) for support when stripping an engine cylinder block. 22. Rotate engine in either direction and lock it into position. 23. Remove the inlet and outlet fuel lines connected to the Motor Control Module (MCM), if equipped. 24.
Remove any electrical components, accessories, connectors or wiring looms from the engine. All information subject to change without notice. 42-10 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION