Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 25. With the engine mounted on the overhaul stand, remove all of any remaining subassemblies and parts from the cylinder block. [a] Remove the rocker cover. Refer to section 1.2. [b] Remove the engine lifter brackets. Refer to section 38.2. [c] Remove the vibration damper. Refer to section 36.1. [d] Remove the flywheel. Refer to section 34.4. [e] Remove flywheel housing. Refer to section 34.2. [f] Remove idler gears. Refer to section 5.2. [g] Remove camshaft housing. Refer to section 3.1. [h] Remove the cylinder head. For DD13, refer to section 14.2. For DD15, refer to section 14.4. [i] Remove the oil pan. Refer to section 19.2.

[j] Remove the piston and connecting rod assembly. Refer to section 15.2. [k] Remove cylinder liners. Refer to section 16.2. [l] Remove the crankshaft. Refer to section 17.2. NOTICE: Before removing main bearing caps, be sure each is stamped or punch-marked in numerical order, beginning with No. 1 at the front, to ensure installation in their original position. Mark all caps on the oil cooler side (left side) of the engine to prevent reversal at assembly. Failure to mark numerical order may result in the caps being put back in incorrect order, improper crankshaft support and severe crankshaft or bearing damage or both. [m] Remove the crankshaft main bearings.

All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 42-11