RAM 1500 — Normal Starting Using ENGINE START/STOP Button — Gasoline Engine

STARTING AND OPERATING 131 The message “AutoPark Engaged Shift to P then Shift to Gear” will display in the instrument cluster. 4WD Low — If Equipped K EYLESS E NTER N G O GNITION NOTE: In some cases the ParkSense graphic will be displayed in the instrument cluster, causing the “AutoPark Engaged Shift to P then Shift to Gear” message to not be seen. In these cases, the gear selector must be returned to “P” to select desired gear. If the driver shifts into PARK while moving, the vehicle may AutoPark. AutoPark will be disabled when operating the vehicle in 4WD Low.

This feature allows the driver to operate the ignition switch with the push of a button, as long as the Remote Start/Keyless Enter ’n Go™ key fob is in the passenger compartment. N ORMAL S TARTING U SING ENGINE START/STOP B UTTON — G ASOLINE E NGINE The message “AutoPark Disabled” will be displayed in the instrument cluster. Additional customer warnings will be given when all of these conditions are met: Vehicle is not in PARK Driver’s door is ajar Vehicle is in 4WD Low range To Turn On The Engine Using The ENGINE START/ STOP Button 4 AutoPark will engage ONLY when vehicle speed is 1.2­mph (1.9­km/h) or less. The message “AutoPark Not Engaged” will be displayed in the instrument cluster.

A warning chime will continue until you shift the vehicle into PARK or the driver’s door is closed. 1. The transmission must be in PARK. The message “Vehicle Speed is Too High to Shift to P” will be displayed in the instrument cluster if vehicle speed is above 1.2­mph (1.9­km/h). 2. Press and hold the brake pedal while pushing the ENGINE START/STOP button once. ALWAYS DO A VISUAL CHECK that your vehicle is in PARK by looking for the "P" in the instrument cluster display and near the gear selector. As an added precaution, always apply the parking brake when exiting the vehicle. T IP S TART F EATURE 3. The system starts the vehicle.

If the vehicle fails to start, the starter will disengage automatically after 10 seconds. WARNING!­ If vehicle speed is above 1.2­mph (1.9­km/h), the transmission will default to NEUTRAL until the vehicle speed drops below 1.2­mph (1.9­km/h). A vehicle left in the NEUTRAL position can roll. As an added precaution, always apply the parking brake when exiting the vehicle. 4. If you wish to stop the cranking of the engine prior to the engine starting, push the button again. Do not press the accelerator. Cycle the ignition switch briefly to the START position and release it. The starter motor will continue to run and will automatically disengage when the engine is running.