132 STARTING AND OPERATING To Turn Off The Engine Using ENGINE START/STOP Button ENGINE START/STOP Button Functions — With Driver’s Foot OFF The Brake Pedal (In PARK Or NEUTRAL Position) wait 10 to 15 seconds, then repeat the “Normal Starting” procedure. 1. Place the gear selector in PARK, then push and release the ENGINE START/STOP button. The ignition will return to the OFF mode. The ENGINE START/STOP button operates similar to an ignition switch. It has three modes: OFF, ACC, and RUN. To change the ignition modes without starting the vehicle and use the accessories, follow these directions:
Never pour fuel or other flammable liquid into the throttle body air inlet opening in an attempt to start the vehicle. This could result in flash fire causing serious personal injury. WARNING! 2. If the gear selector is not in PARK, the ENGINE START/STOP button must be held for two seconds or three short pushes in a row with the vehicle speed above 5mph (8km/h) before the engine will shut off. The ignition will remain in the ACC mode until the gear selector is in PARK and the button is pushed twice to the OFF mode. 1. Start with the ignition in the OFF mode. Do not attempt to push or tow your vehicle to get it started.
Vehicles equipped with an auto matic transmission cannot be started this way. Unburned fuel could enter the catalytic converter and once the engine has started, ignite and damage the converter and vehicle. 2. Push the ENGINE START/STOP button once to place the ignition to the ACC mode. 3. Push the ENGINE START/STOP button a second time to place the ignition to the RUN mode. 3. If the gear selector is not in PARK and the ENGINE START/STOP button is pushed once with the vehicle speed above 5mph (8km/h), the instrument cluster will display a “Vehicle Not In Park” message and the engine will remain running. Never leave a vehicle out of the PARK position, or it could roll.
If the vehicle has a discharged battery, booster cables may be used to obtain a start from a booster battery or the battery in another vehicle. This type of start can be dangerous if done improperly Ъ page354. 4. Push the ENGINE START/STOP button a third time to return the ignition to the OFF mode. If Engine Fails To Start If the engine fails to start after you have followed the “Normal Starting” procedure, it may be flooded. Push the accelerator pedal all the way to the floor and hold it there while the engine is cranking. This should clear any excess fuel in case the engine is flooded. NOTE:
If the gear selector is not in PARK, and the ENGINE START/STOP button is pushed once with the vehicle speed below 5mph (8km/h), the engine will shut off and the ignition will remain in the ACC position. If vehicle speed drops below 1.2mph (1.9km/h), the vehicle may AutoPark Ъ page130. CAUTION! To prevent damage to the starter, do not crank the engine for more than 10 seconds at a time. Wait 10 to 15 seconds before trying again. The starter motor will engage automatically, run for 10 seconds, and then disengage. Once this occurs, release the accelerator pedal and the brake pedal,