STARTING AND OPERATING 133 If the engine has been flooded, it may start to run, but not have enough power to continue running when the ignition button/key is released. If this occurs, continue cranking with the accelerator pedal pushed all the way to the floor. Release the accelerator pedal and the ignition button/key once the engine is running smoothly. NOTE: A delay of the start, up to five seconds is possible under very cold conditions. The "Wait to Start" telltale will be illuminated during the pre-heat process. When the engine “Wait To Start” light goes off the engine will automatically crank. To Turn Off The Engine Using ENGINE START/STOP Button 1.
Place the gear selector in PARK, then push and release the ENGINE START/STOP button. The ignition will return to the OFF mode. CAUTION! 2. If the gear selector is not in PARK, the ENGINE START/STOP button must be held for two seconds or three short pushes in a row with the vehicle speed above 5mph (8km/h) before the engine will shut off. The ignition will remain in the ACC mode until the gear selector is in PARK and the button is pushed twice to the OFF mode. If the engine shows no sign of starting after a 10 second period of engine cranking with the accelerator pedal held to the floor, wait 10 to 15 seconds, then repeat the “Normal Starting” procedure.
N ORMAL S TARTING U SING ENGINE START/STOP B UTTON — D IESEL E NGINE If the “Water in Fuel Indicator Light” remains on, DO NOT START the engine before you drain the water from the fuel filter to avoid engine damage Ъ page378. 4 3. The system starts the vehicle. If the vehicle fails to start, the starter will disengage automatically after 25 seconds. 3. If the gear selector is not in PARK and the ENGINE START/STOP button is pushed once with the vehicle speed above 5mph (8km/h), the instrument cluster will display a “Vehicle Not In Park” message and the engine will remain running. Never leave a vehicle out of the PARK position, or it could roll.
Observe the instrument panel telltales when starting the engine. 4. If you wish to stop the cranking of the engine prior to the engine starting, push the button again. NOTE: Normal starting of either a cold or a warm engine is obtained without pumping or pressing the accel erator pedal. To Turn On The Engine Using The ENGINE START/ STOP Button NOTE: Normal starting of either a cold or a warm engine is obtained without pumping or pressing the accel erator pedal. NOTE: If the gear selector is not in PARK, and the ENGINE START/STOP button is pushed once with the vehicle speed below 5mph (8km/h), the engine will shut off and the ignition will remain in the ACC position.
If vehicle speed drops below 1.2mph (1.9km/h), the vehicle may AutoPark Ъ page130. 1. The transmission must be in PARK (P). 2. Press and hold the brake pedal while pushing the ENGINE START/STOP button once.