134 STARTING AND OPERATING ENGINE START/STOP Button Functions — With Driver’s Foot OFF The Brake Pedal (In PARK Or NEUTRAL Position) S TARTING F LUIDS — D IESEL E NGINE O NLY WARNING! Do not leave the key fob in or near the vehicle, or in a location accessible to children, and do not leave the ignition of a vehicle equipped with Keyless Enter ‘n Go™ in the ACC or ON/ RUN mode. A child could operate power windows, other controls, or move the vehicle. The ENGINE START/STOP button operates similar to an ignition switch. It has three modes: OFF, ACC, and RUN. To change the ignition modes without starting the vehicle and use the accessories, follow these directions:
The engine is equipped with a glow plug preheating system. If the instructions in this manual are followed, the engine should start in all conditions and no type of starting fluid should be used. 1. Start with the ignition in the OFF mode. WARNING! 2. Push the ENGINE START/STOP button once to place the ignition to the ACC mode. Do not leave children or animals inside parked vehicles in hot weather. Interior heat build up may cause serious injury or death. NORMAL OPERATION — DIESEL ENGINE 3. Push the ENGINE START/STOP button a second time to place the ignition to the RUN mode.
When leaving the vehicle, always make sure the wireless ignition node is in the “OFF” mode, remove the key fob from the vehicle and lock the vehicle. Observe the following when the diesel engine is operating. All message center lights are off. Malfunction Indicator Light (MIL) is off. 4. Push the ENGINE START/STOP button a third time to return the ignition to the OFF mode. Engine Oil Pressure telltale is not illuminated. C OLD W EATHER O PERATION (B ELOW –22°F O R −30°C) Never leave children alone in a vehicle, or with access to an unlocked vehicle. Allowing chil dren to be in a vehicle unattended is dangerous for a number of reasons. A child or others could be seriously or fatally injured.
Children should be warned not to touch the parking brake, brake pedal or the gear selector. Voltmeter operation: The voltmeter may show a gauge fluctuation at various engine temperatures. This is caused by the glow plug heating system. The number of cycles and the length of the cycling operation is controlled by the engine control module. Glow plug heater operation can run for several minutes, once the heater operation is complete the voltmeter needle will stabilize. To ensure reliable starting at these temperatures, use of an externally powered electric engine block heater (available from an authorized dealer) is recommended.
A FTER S TARTING (Continued) The idle speed is controlled automatically, and it will decrease as the engine warms up.